You can also use wsl -terminate to terminate a a specific distribution that's running instantly. The command wsl -shutdown is a fast path to restarting WSL 2 distributions, but it will shut down all running distributions, so use wisely. If no distributions are running, you will receive the response: "There are no running distributions." You can now restart the distribution to see your configuration updates applied. You can check to see whether your Linux distribution (shell) is still running after closing it by using PowerShell with the command: wsl -list -running. You must wait for the subsystem to stop before relaunching in order to give enough time for your changes to be picked up. This is not currently the case as the subsystem could still be running. Ubuntu), modify the configuration file, close the distribution, and then re-launch it, you might assume that your configuration changes have immediately gone into effect. This typically takes about 8 seconds after closing ALL instances of the distribution shell. You must wait until the subsystem running your Linux distribution completely stops running and restarts for configuration setting updates to appear. The 8 second rule for configuration changes Check which version of WSL you are running. WSL 2 runs as a lightweight virtual machine (VM), so uses virtualization settings that allow you to control the amount of memory or processors used (which may be familiar if you use Hyper-V or VirtualBox). WSL 1 and WSL 2 run with different architecture and will impact the configuration settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |